stevenhowes/MX5-Arduino-Speed
1
0
Fork 0
mirror of https://github.com/stevenhowes/MX5-Arduino-Speed.git synced 2026-05-26 15:53:40 +01:00
Code Issues Packages Projects Releases Wiki Activity

Friday

Browse Source
This commit is contained in:
stevenhowes
2019-07-19 10:27:29 +01:00
committed by GitHub
parent dee5f6b147
commit e74ceeb7f0
1 changed files with 4 additions and 4 deletions
Download Patch File Download Diff File Expand all files Collapse all files
README.md
+4 -4
View File
@@ -1,6 +1,6 @@
# MX5-Arduino-Speed # MX5-Arduino-Speed
##Target Hardware ## Target Hardware
Arduino ATMega328p Arduino ATMega328p
@@ -10,7 +10,7 @@ Arduino ATMega328p
5v Speed sensor (#DSSA from www.carbuildersolutions.com) 5v Speed sensor (#DSSA from www.carbuildersolutions.com)
##Pinout ## Pinout
OLED_MOSI 9 OLED_MOSI 9
@@ -26,7 +26,7 @@ Beeper 2 (and to GND)
Speed sesor 4 (and 5v, GND) Speed sesor 4 (and 5v, GND)
##Configuration commands (via USB Serial 115200) ## Configuration commands (via USB Serial 115200)
ODO - Press return and then enter new odometer reading ODO - Press return and then enter new odometer reading
@@ -36,7 +36,7 @@ CAL - Enter calibration mode (see below)
RUN - Exit calibration mode RUN - Exit calibration mode
##Calibration mode ## Calibration mode
In calibration mode it starts counting pulses immediately. Calibration should be done over a measured half a mile. Press enter when starting the half mile, and again at the end. The number of pulses will be displayed on the screen. To write this to EEPROM and return to normal mode type 'RUN'. If the data is not suitable (missed marker etc) then just repeat the measurement. In calibration mode it starts counting pulses immediately. Calibration should be done over a measured half a mile. Press enter when starting the half mile, and again at the end. The number of pulses will be displayed on the screen. To write this to EEPROM and return to normal mode type 'RUN'. If the data is not suitable (missed marker etc) then just repeat the measurement.